|
- Position
with the ramp toward you and hold the wheel plates.
- With the 'LEAD IN' edge of the plate nearest
to you and facing outwards locate them on the ramp plate.
- Assemble using the four M8 COACH BOLTS fitting
them up through the ramp slots and square holes in the wheel plates,
now locate the M8 WASHERS AND M8 LOCKING NUTS.
- Determine the width of your tyre and set the inner edge of
the wheel plates to the corresponding position on the measuring
scale. NOTE: Tyre sizes can vary according to make so
ensure the plates are always adjusted for close contact with the
tyre.
- Lock the four M8 BOLTS securely with a 13mm
WRENCH ''the stand is now ready for use''
- Position
directly in-line with the appropriate wheel and roll the bike
home.
- For cruisers with front tyres larger than 140mm the
wheel plates will need to be reversed a lead is provided at both
ends for this purpose. (Normal position shown in diagram)
Always take time and practice a little to become proficient
in use, as rolling the bike up onto the plates instead of between
them can cause a sudden shift in weight and en-balance the bike!
when using on slippery surfaces ANTI SLIP PADS are
provided to arrest movement in more severe cases a rubber foot mat
can be placed under the stand.
When used for transportation, either bolted down on a trailer or
in a van be sure to securely fasten the bike down with tie straps
Note: there is no need to compress the front suspension
with this stand
Always check the suitability
of use for your application and stability as differing surfaces
can sometimes cause stability problems.
If in any doubt contact us for
advice!
Your bike has never been this safe
before, Wise choice!
Used by STENA-LINE Shipping Gothenburg !!
|
