EazyRizer BIG BLUE Assembly
&
Instruction Sheets

1. Remove all packaging and check contents, now take the lifting pillar FIG C and after removing the screw-shaft assembly assemble it with base FIG B using the six M10 x 35 bolts and tighten them to 40 ft Ib.
   
   
2. Turn upside down and fit the two wheel assemblies as shown in the diagram FIG 12 tightening the bolts until resistance is felt then back off a quater of a turn until the wheel is free to turn
   
   
3. With the lift in the normal position take the lifting arm FIG A and remove the two outer guide bolts and fittings, now using a small amount of grease (supplied) fit the 8 nylon guides FIG 9 into their respective holes from the inside.
   
   
4. Place the lifting arm onto the pillar and re-fit the two outer guides tightening all four bolts to 40 Ib ft and check that the lifting arm is free to move up and down the lift.
   
   
5. Take the screw-shaft assembly and after greasing the bearing FIG 3 re-fit it to the lift as shown in the diagram, be sure to locate the large rubber buffer FIG 5 before screwing it through the bronze lifting nut in the arm FIG A.
   
   
6. Continue screwing the shaft until it travels through the base plate and fit the nylon bush, small rubber buffer and 14mm washer as shown FIG's 4/6/7 and finally the split pin FIG 8.
   
   
7. Assembly is now complete, lubricate the entire length of the shaft with the grease and with your power drill run the machine up & down several times. The lift is now ready to use.
   

PRE-ASSEMBLY CHECK LIST